Battery Replacement - Dimplex DF3003 Owner's Manual

Operation
remains on, the heater is set
to the high heat setting, and all
three red indicators illuminate.
Remote Control Initialization/
Reprogramming
Follow steps 1 through 6 to
initialize your fireplace for the
first time. This procedure is also
required every time there is a loss
of power to the remote control
in the fireplace (I.E. power fail-
ure, breaker tripped, main power
switch is turned off).
1. Ensure that power is supplied
through the main service
panel.
2. Locate manual controls.
3. Activate main power switch.
4. Press and hold the ON switch
marked "
(red indicator light will flash).
5. Press the ON button located
on the remote control.
This will synchronize the remote
control and receiver.
12
" for five seconds
Figure 4
On
Button
Off
Button
Plastic
strip
Battery
cover

Battery Replacement

(Figure 4)
To replace the battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 12 Volt
(A23) battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
www.dimplex.com