Start/Pause Button; Programmes Procedure - Electrolux EWT 1058 Instruction Manual

15 15
4 4
Incorrect selection
E r r
Error codes
E40 E40

9. Start/Pause button

After having selected the wash programme, press this
button to start the appliance; the corresponding light
stops flashing.
If you have selected a delay start, the timer starts.
The time remaining window displays the duration of the
programme or the delay start time.
If you select a function which
is not compatible with the
chosen wash programme,
the time remaining window
displays "Err".
Any operating faults are
shown by an error code on
the display. The error code
provides assistance for us-
ers and for the After-Sales
Department (see pages 19
and 20).
This button has three
functions:
Start - Pause - Continuation
of the cycle after stopping
with the tub full or after
soaking.
Start
The programme in progress is interrupted when this
button is pressed. It continues when this button is
pressed again. During the pause, the light of the Start/
Pause button flashes.
By pressing the Start/Pause button:
• The water from the soak programme is drained.
• The water from programmes with rinse hold is drained
(button selected) and the washing is spun.

10. Programmes procedure

When you select a programme, the lights corresponding
to the various phases within the programme illuminate.
When the programme starts, only the immediate opening
light "Door" and the phase in progress light remains
illuminated.
If one of the lights as follow and the "DSP" light flash at
the same time than an error code on the display window,
the following faults may have occurred:
• E10 + "Rinse" light:
==> the appliance is not filling.
• E20 + "Wash" light:
==> the appliance is not draining.
• E40 + "Prewash" light:
==> the lid is not closed properly.
See the "Troubleshooting" section on page 19 to remedy
the fault.
9
Pause
Drain