Electrolux EWT 1058 Instruction Manual page 20

Symptoms
The machine vibrates or is very
noisy.
The lid does not open.
The wash cycle is much too long.
The machine stops during a wash
cycle.
The laundry
sufficiently or water remains in
the drum (error code E20).
Softener flows out of the overflow
hole.
is not spun
Check that:
- the transit bolts have been removed (see "removing
transit bolts" section),
- the appliance is level and installed correctly,
- the appliance is not too close to a wall or other
furniture,
- the laundry is correctly distributed in the drum,
- the appliance is not overloaded.
- the appliance is in the heating phase,
- the lid is still locked.
Check that:
- the water pressure is sufficient,
- the water inlet filter is not blocked,
- there is not a water cut
Check that:
- the water pressure is sufficient,
- the water inlet filter is not blocked,
- the fuses are in good condition and have not blown,
- the appliance is not finishing its wash programme
by a rinse hold.
Check that:
- the drain hose is not kinked,
- the height of the end of the drain hose is not higher
than on metre,
- the drain pump filter is not blocked ("Filter" light
illuminated),
Check that:
- you have used the correct amount,
- the siphons on the rear of the detergent dispenser
are not blocked.
20
Solutions