Table of Contents
Advertisement
Electrical connection
The appliance is set up for a single-phase 230V feeling
voltage. The connection has to be carried out in compliance
with the current directives and law dispositions.
Before connecting the hob make sure that:
The shaping valve and the electrical system can stand the
•
appliance load (see the serial number indicated on the rating
plate);
• The feed system of the appliance has a proper earth
connection, according the laws in force
• The tap or the single-pole circuit breaker are easy to be
reached from the installed appliance.
Mount on the cable a suitable tap for the load and connect it to
a proper safety tap.
If a straight connection to the electricity is desired, it is
necessary to put a single-pole, with a minimum opening of
3mm dimensioned to the load and in compliance with the
current directives, between the appliance and the network.
The brown phase wire (coming out from the L terminal on the
terminal board) must be always connected to the phase of the
feeding network.
In any case the feeding wire has to be positioned so that it
cannot reach, anywhere in its length, a temperature higher
than 50°C.
An example of optimal current path is indicated on Fig. 3. The
wire is guided by the employment of clamps fixed on the side
of the furniture, in order to avoid any contact with the appliance
under the hob
Replacing the electrical power
cable
If necessary the electrical power must be replaced
exclusively with power cables type H05V2V2-F T90
suitable for the load and temperature rating.
It is also important that the earth wire (Yellow/Green)
must be at least 2 cm longer than the other phase
neutral (Figure 4-5).
The replacement of the cable has to be done by
qualified personnel only, in order to prevent any kind of
risks.
8
;
Fig.5
Fig.3
Fig.4
Advertisement
Table of Contents
