Functions Used When Receiving Calls; Answering Calls - Siemens HiPath 1100 User Manual

Step by step
It is also possible to configure the system so that
it is either mandatory or optional to enter an ac-
count code at the start of the call. These settings
can be configured using HiPath 1100 Manager
(see Account codes - A31003-K1160-B810-*-*) or
programming code (see Programming Manual,
A31003-K1160-B804-*-*, Account code type).
The account code can be configured in advance
using HiPath 1100 Manager (see Account codes
- A31003-K1160-B810-*-*). If it has been config-
ured and the option to validate the account code
is selected, only the configured codes will be ac-
cepted. If an invalid account code is typed in, a
negative tone will sound or a message will be
displayed.
Functions used when receiving
calls

Answering calls

Extensions receive different ringing signals and tones
depending on the type of call being received and the
specified country setting. For example, some types of
ringing signals are:
• When receiving an internal call or callback, the tele-
phone rings twice (two short beeps) at 4-second in-
tervals (double sequence).
• When receiving an external call, the telephone rings
once (single beep) at 4-second intervals
• When receiving an entrance telephone call, the tele-
phone rings three times (triple beeps) at 4-second
intervals.
• When receiving a second call, a short tone (beep) is
heard at 6-second intervals.
• When receiving an alarm clock call, the telephone
rings twice (a long and a short beep) at 4-second in-
tervals).
• On system telephones volume control is adjusted
individually on each set during calls.

Functions used when receiving calls

57