Siemens HiPath 1100 User Manual page 49

Step by step
CONF:n PARTIC.
ADD PARTIC.?
CONFERENCE?
CONFERENCE
Adding a participant
Required: A conference with more than three speakers
activated and the extension as master.
The display shows the number of participants.
Select and confirm.
p
Enter the extension (e.g., 12/102) or dial the access
code for an external line (e.g., 0) then the number to be
included in the conference.
w
Wait for the call to be answered.
s
Inform the person about the conference.
Select and confirm.
or
Press to access the Service menu.
qg
Enter the code to add the participant.
or
Press the "Conference" key
w
Wait.
s
Start the conference.
Considerations:
• During consultation status, the master extension
will temporarily be left out of the conference. If one
of the slaves disconnects from a conference with
only 2 slaves, the conference will be ended and the
other will be placed on hold.
• When the master makes more than one consulta-
tion, the Toggle feature will switch between the last
two calls on hold.
• A new participant may only be added if there is only
one slave on hold. If more than one participant is on
hold, the master should disconnect them until only
one is left, and then add the new participant.
• The TAPI interface only supports 3 participants in a
conference, therefore it is not possible to add a
fourth member if at least one of the participants is
being monitored by the TAPI
Functions used during calls
49