Power Over Ethernet Specifications - Alcatel-Lucent OmniSwitch 6250-24M User Manual

Managing Power over Ethernet (PoE)

Power over Ethernet Specifications

The table below lists general specifications for Alcatel-Lucent's Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to
"OmniSwitch 6250 Chassis and Hardware Components."
IEEE Standards supported
Default PoE administrative status
Default PoE operational status
Platforms supporting PoE
Cable distances supported
Total number of PoE-capable ports per switch
Default amount of inline power available (1-6, 23/24 or
25/26)
Default amount of inline power available (7-24)
Range of inline power allowed (1-6, 23-24 or 25-26)
Range of inline power allowed (7-22)
PoE Power Supply
Note. Ports pairs 23/24 and 25/26 cannot have PoE enabled at the same time. By default, ports 23/24 have
PoE capability enabled and ports 25/26 have PoE capability disabled. See
Copper Combo Ports" on page 5-6
OmniSwitch 6250 Hardware Users Guide
IEEE 802.3af; 802.3at
Enabled
Disabled (PoE must be activated on a switch-
by-switch basis via the
mand.)
OmniSwitch 6250-P24
100 meters (approx.)
24
31000 milliwatts
16000 milliwatts
3000 - 31000 milliwatts
3000 - 16000 milliwatts
225 Watts
for information on enabling PoE on the copper combo ports.
June 2012
Power over Ethernet Specifications
Chapter 2,
lanpower start com-
"Enabling/Disabling PoE on
page 5-3