Checking Redundant Stacking Cable Status - Alcatel-Lucent OmniSwitch 6250-24M User Manual

Managing OmniSwitch 6250 Stacks
Redundant stacking cables provide a form of dual redundancy. As shown in the figure above, the redun-
dant cable allows traffic to flow in the event of a stacking link failure. The redundant cable also provides
failover if a switch goes down within the stack. Traffic continues to flow between the modules that remain
operational, as shown in the diagram below:
Stacking Cables
Stacking Cable Redundancy: Recovery Following a Switch Failure within the Stack

Checking Redundant Stacking Cable Status

To check whether a redundant stacking cable connection exists between the top-most and bottom-most
switches in the stack, use the
-> show stack status
Redundant cable status
In this example, a redundant stacking cable connection is present between the top-most and bottom-most
switches in the stack.
OmniSwitch 6250 Hardware Users Guide
Chassis Front
1
Slot 1
Slot 2
Slot 3
Slot 4
Slot 1 2
Slot 2
Slot 3
Slot 4
show stack status command. For example:
: present
June 2012
Data enters slot 1 through an Ethernet port. The data
traverses slot 2 via the stacking cables and exits slot 3
through one of its Ethernet ports.
The slot 2 switch goes down unexpectedly. Data can no
longer move through slot 2.
However, because there is a redundant connection (the
cable between slot 1 and slot 4), data immediately
traverses slot 4 and then exits slot 3 to its destination.
Stack Cabling
page 6-19