Initializing the i2004 Internet Telephone
When you first connect your i2004 Internet Telephone to a power source, all
hardkey indicator lights and softkey icons may flash. This indicates that the
phone has not yet been initialized. You may need to contact your system
administrator to determine the correct information to use during the initialization
procedure.
To begin the initialization process, you must enter a PASSWORD while the
introduction screen appears after powering your i2004 Internet Telephone. If no
password is entered, or a password is not entered within the first two seconds of
the initialization process, your set will be initialized automatically. Automatic
initialization will utilize the default entries and will not be stored in your set's
permanent memory. (See Figure 6.)
Figure 6
i2004 Internet Telephone - User Guide • © 2000 • NTC51.00.02.24
Version 8-6 • Page 11