Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts; Connecting/Using A Decoder - JVC DR-MV1 Instructions Manual

Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not supplied)
DIGITAL AUDIO OUT (COAXIAL)
2
Note for connection:
Remove the protection cap from the cable.
1
Connect the unit and a Dolby Digital decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
For Dolby Digital sound, set "DIGITAL AUDIO OUT" to "DOLBY
DIGITAL/PCM". ( pg. 78)
For DTS sound, set "DIGITAL AUDIO OUT" to "STREAM/PCM".
( pg. 78)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Optical cable
(not supplied)
DIGITAL AUDIO OUT (OPTICAL)
When you can't switch the audio chaonnel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and "DIGITAL AUDIO OUT" is set to "DOLBY
DIGITAL/PCM", it is not possible to switch the audio channel of a
bilingual programme recorded on a DVD-RAM or DVD-RW (VR
mode) disc. In this case, perform the following steps using the
remote control to switch "DIGITAL AUDIO OUT" from "DOLBY
DIGITAL/PCM" to "PCM ONLY".
A Press SET UP to access the Main Menu screen.
B Press w e to select "DVD SET UP", then press ENTER.
C Press w e to select "AUDIO OUTPUT", then press ENTER.
D Press rt to select "DIGITAL AUDIO OUT", then press
ENTER.
E Press rt to select "PCM ONLY", then press ENTER.
( pg. 78)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel. (

Connecting/Using A Decoder

The L-2 IN/DECODER connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
Decoder
TV
1
Set "L-2 SELECT" to "DECODER". (
2
Connect your unit's L-2 IN/DECODER connector to the
decoder's 21-pin SCART connector using a 21-pin SCART cable.
3
Perform the procedure as described in "When Receiving A
Scrambled Broadcast" (
SYSTEM CONNECTION
TV aerial cable
L-1 IN/OUT
L-2 IN/DECODER
RF cable
(provided)
pg. 72)
pg. 84).
77
EN
pg. 28)