Manual Dubbing (From Vcr To Dvd) - JVC DR-MV1 Instructions Manual

EDITING
66
EN

Manual Dubbing (From VCR To DVD)

Dubbing A Part Of A Cassette
You can dub the selected scenes on a tape to the DVD disc,
starting and stopping wherever you wish.
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
VCR/DVD
VCR/DVD
3
8
REC MODE
4 9 5
8 73
SAT
1 2 3
4 5 6
7 8 9
0
4
5
9
7
1
For DVD deck
Load a recordable disc.
For VCR deck
Load a cassette you want to dub.
2
Press VCR] to select the dubbing direction.
"VCR]" lights up on the front display panel.
3
Prepare the VCR deck for dubbing.
A Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
B Locate the point from where you want to start dubbing, then
pause playback by pressing the following buttons: 4, 5, 3,
VCR ]
8, 9
4
Prepare the DVD deck for dubbing.
A Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
B Press REC MODE repeatedly to set the recording mode.
C Press and hold 9, then press 7 so that the DVD deck enters
the Record Pause mode.
5
Press and hold DUB for more than 2 seconds to start dubbing.
DUB
6
Press 8 to stop recording on the DVD deck. Then press VCR/
DVD, and press 8 to stop playback on the VCR deck.
NOTES:
If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to dub. It is recommended to
conduct a test with unimportant cassettes first.
There may be a discrepancy of several seconds between where you
intend dubbing to start, and where it actually stars.
The superimposed indication during the operation or dubbing is not
recorded.
It is not possible to dub a tape with a copy protection signal.
If the recording capacity of disc become full, the tape stops
automatically.
It is not possible to perform other operations like Live Memory
Playback. Check the recorded programme on the disc after dubbing.
Dubbing is not possible on the discs used exclusively for On-Disc
Timer Programming.