Connecting To A Dolby Digital Decoder Or An Amplifier With A Built-In Dts (Dvd Deck Only) - JVC XVC26U - DVD/VCR Instructions Manual

Filename [XVC27U_09Editing.fm]
XVC27U_01.book Page 73 Wednesday, January 7, 2004 10:48 AM
Connecting To A Dolby Digital Decoder
or An Amplifier With A Built-in DTS
(DVD deck only)
These instructions enable you to connect your unit to dolby digital decoder or amplifier with a built-in DTS.
Dolby Digital decoder or
To DIGITAL AUDIO
amplifier with a built-in DTS
input
Make connections.
Connect the coaxial cable between the unit and the
Dolby Digital decoder or amplifier with a built-in DTS.
NOTES:
For Dolby digital sound, set "DIGITAL AUDIO OUTPUT" to
"DOLBY DIGITAL/PCM". (
For DTS sound, set "DIGITAL AUDIO OUTPUT" to "STREAM/
PCM". ( pg. 78)
Page 73
Coaxial cable
(not supplied)
pg. 78)
DIGITAL AUDIO OUT
Back of unit
CAUTIONS:
This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
Masterpage:Right-No-Heading
73
EN
6 January 2004 7:51 pm