Mode Set (Vcr Deck) - JVC DR-MV1 Instructions Manual

SUBSIDIARY SETTINGS
80
EN

Mode Set (VCR Deck)

Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
VCR/DVD
ENTER
SET UP
You can change various mode settings on the Function Set screen.
To change the settings of these modes, find the desired mode in
the menu (for details on each menu, see pages 80 through 81),
then follow the procedure below.
1
Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
2
Press SET UP to access the Function Set screen.
3
Press rt to select the item you want to change, then press
ENTER or e to select the desired mode.
4
Press SET UP to complete the setting.
SAT
1 2 3
4 5 6
7 8 9
0
rtw e
* The boldface settings below indicate the settings at your purchase.
8 B.E.S.T. — ON / OFF
You can set the B.E.S.T. (Biconditional Equalised Signal Tracking)
system to "ON" or "OFF". (
NOTES:
When watching a tape recorded with "B.E.S.T." set to "ON", it is
recommended that you leave B.E.S.T. on during playback as well.
When watching a rental tape or one recorded on another video
recorder, or when using this unit as the player for editing, set B.E.S.T.
to your preference.
The B.E.S.T. system works for both SP and LP modes only after a
tape has been inserted and the Record mode is first initiated. It does
not work during recording.
The B.E.S.T. system does not work while Automatic Satellite
Programme Recording is in progress. (
In the case of timer recordings, the B.E.S.T. system works before
recording is initiated.
Once the cassette is ejected, the B.E.S.T. data is cancelled. The next
time the cassette is used for recording, B.E.S.T. is re-performed.
Pressing the unit's 7 button while "BEST" is displayed does not start
Instant Timer Recording. (
8 PICTURE CONTROL — AUTO / EDIT / SOFT / SHARP
This feature helps you to adjust the playback picture quality
according to your preference. Normally select "AUTO".
AUTO
: Picture quality is adjusted automatically.
EDIT
: Minimizes picture degradation during editing (recording and
playback).
SOFT
: Reduces image coarseness when viewing overplayed tapes
containing a lot of noise.
SHARP
: Clearer, sharper-edged picture when viewing images with
lots of flat, same-colored surfaces such as cartoons.
NOTES:
When you select "EDIT", "SOFT" or "SHARP", the selected mode will
not change until you select another mode.
When you select "EDIT" to dub tapes, be sure to select "NORM" after
you finish dubbing the tapes.
When "B.E.S.T." is "OFF", "PICTURE CONTROL" switches
automatically from "AUTO" to "NORM".
8 O.S.D. — AUTO / OFF
When this function is set to "AUTO", various operational indicators
appear on the TV screen. Messages appear in the selected
language. ( pg. 20)
NOTES:
Even when "O.S.D." is set to "OFF", you can display the various
operational indicators by pressing ON SCREEN. To clear the
operational indicators, press ON SCREEN again.
When you use this unit as the source player for editing, be sure to set
"O.S.D." to "OFF" before starting.
During playback, the operation mode indicators may be disturbed
depending on the type of tape being used.
pg. 53)
pg. 48)
pg. 53)