Basic Recording; Recording Features - JVC DR-MV1 Instructions Manual

OPERATIONS ON VCR DECK
52
EN

Basic Recording

Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
VCR/DVD
VCR/DVD
8
REC MODE
1
Load a cassette with the record safety tab intact.
The unit's power comes on automatically and the counter is reset to
0:00:00.
2
Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
3
Press PR +/– or the number keys to select the channel you
wish to record.
4
Press REC MODE repeatedly to set the recording mode.
5
Press 7 on the unit to start recording. Or press and hold 7 and
press 4 on the remote control.
The VCR recording lamp lights up on the unit.
If "O.S.D." is set to "ON" (
while an index code is being marked.
B.E.S.T. takes place at the beginning of both the first SP and the
first LP recording after inserting the cassette. (
If "DIRECT REC" is set to "ON", the programme that appears on
the TV screen will be recorded. (
6
Press 9 to pause recording.
You can select channel during the Record Pause mode.
To resume recording, press 4.
7
Press 8 to stop recording.
The VCR recording lamp lights off on the unit.
Recording Resume Function
If there is a power outage during recording, Instant Timer
Recording or timer recording (
resume automatically when power is restored to the unit unless the
unit's memory backup has expired.
4 7 9
REC MODE PR +/–
8
SAT
1 2 3
4 5 6
0 – 9
7 8 9
0
4
9
7
PR +/–
pg. 80), "MARK" blinks on the screen
pg. 53)
pg. 81)
pg. 52, 54, 55), the recording will

Recording Features

Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
Press VCR/DVD repeatedly so that the VCR lamp lights up on the
unit.
VCR/DVD
CANCEL
TV/VCR
Watch Another Programme While Recording On The
Unit
While recording is going on, you can watch another programme on
the TV by using the TV's tuner.
NOTE:
It is required that the remote control is set to be able to operate the TV
in advance. ( pg. 74)
1
During recording, press TV/VCR to select TV mode if your unit
is connected to the TV via the RF connection.
VCR mode is disengaged, then the VCR indicator lights off and "TV"
appears on the front display panel.
VCR indicator lights off.
The programme received on the TV's tuner is displayed on the TV
screen.
2
Slide the TV/CABLE/SAT/DVD switch to TV.
3
Press PR +/– repeatedly to select the desired channel.
Accidental erasure
prevention
To prevent accidental recording on
a recorded cassette, remove its
safety tab. To record on it later,
cover the hole with adhesive tape.
7
SAT
1 2 3
4 5 6
7 8 9
0
DISPLAY
PR +/–
Record safety tab