Snapshot - JVC GR-DVL157 Instructions Manual

30
EN
SNAPSHOT Button
Power Switch
Display
SNAP MODE – P I N–UP
FRAME
FUL L
MUL T I – 4
MUL T I – 9
PIN-UP
Pin-Up mode*
FULL
Snapshot mode with
no frame*
MULTI-9
Multi-Analyser 9
* There is the sound effect of a shutter closing.
Lock Button
Menu Screen
FRAME
Snapshot mode with
frame*
MULTI-4
Multi-Analyser 4
FOR RECORDING

Snapshot

This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
Set the Power Switch to "
Lock Button located on the switch.
2
Press the MENU/BRIGHT wheel in. The Menu Screen
appears.
3
Rotate the MENU/BRIGHT wheel to select "
CAMERA". Press it and the CAMERA Menu appears.
4
Rotate the MENU/BRIGHT wheel to select "SNAP
MODE", then press it.
5
Rotate the MENU/BRIGHT wheel to select the desired
Snapshot mode, then press it.
Rotate the MENU/BRIGHT wheel to select
"1RETURN" and press it twice. The Menu Screen closes.
SNAPSHOT RECORDING
1
Press SNAPSHOT.
If you press during Record-Standby . . .
..... "PHOTO" appears and a still image will be recorded
for approx. 6 seconds, then the camcorder re-enters
the Record-Standby mode.
If you press during Recording . . .
..... "PHOTO" appears and a still image will be recorded
for approx. 6 seconds, then the normal recording
resumes.
• Regardless of the Power Switch position ("
Snapshot recording takes place using the selected
Snapshot mode.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to serial
photography. (Interval between still images: approx. 1 second)
NOTES:
To remove the shutter sound,
Even if "MULTI-4" or "MULTI-9" is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom or Night-Scope (
If Snapshot recording is not possible, "PHOTO" blinks when
SNAPSHOT is pressed.
If Programme AE with special effects (
certain modes of Programme AE with special effects are
disabled during Snapshot recording. In such a case, the icon
blinks.
If SNAPSHOT is pressed when "DIS" is set to "ON"
( pg. 35), the Stabiliser will be disabled.
During tape playback as well, all snapshot modes are
available. However, the shutter sound is not heard.
During Snapshot recording, the image displayed in the
viewfinder may be partially missing. However, there is no
effect in the recorded image.
When a cable is connected to the AV connector, the shutter
sound is not heard from the speaker, however it is recorded
onto the tape.
will appear while the snapshot is being taken.
(cont.)
" while pressing down the
" or "
"BEEP" on pg. 34, 36.
pg. 26).
pg. 26) is engaged,
"),