Table of Contents
Advertisement
18
EN
Power Switch
SNAPSHOT
Button
Display
SNAP MODE
–
P I N–UP
FRAME
FUL L
MUL T I – 4
MUL T I – 9
NEGA POS I
FULL
Snapshot mode
with no frame* √
MULTI-9
Multi-Analyser 9
PIN-UP
Pin-Up mode √
* There is the sound effect of a shutter closing.
√ When "FULL", "FRAME", "PIN-UP" or "NEGA
POSI" is selected, snapshot recording will always be
performed with higher quality (
"CAMERA MODE" is set to "VIDEO".
Downloaded from:
RECORDING
Shooting
Mode Switch
Lock Button
Menu Screen
MULTI-4
Multi-Analyser 4
NEGA POSI
Nega/Posi mode* √
FRAME
Snapshot mode
with frame* √
pg. 22) even if
https://www.usersmanualguide.com/
Basic Recording For Video (cont.)
Snapshot (For Video Recording)
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
Set the Shooting Mode Switch to "VIDEO", then set the
Power Switch to "
Button located on the switch. Pull out the viewfinder
fully or open the LCD monitor fully.
2
Press the MENU wheel. The Menu Screen appears.
3
Rotate the MENU wheel to select "
it and the CAMERA Menu appears.
4
Rotate the MENU wheel to select "SNAP MODE", then
press it.
5
Rotate the MENU wheel to select the desired Snapshot
mode, then press it.
Rotate the MENU wheel to select "1RETURN" and press
it twice. The Menu Screen closes.
SNAPSHOT RECORDING
1
Set "CAMERA MODE" to "VIDEO" or "PS-VIDEO" in the
Menu Screen (
pg. 26, 27).
2
Press SNAPSHOT.
If you press during Record-Standby . . .
..... "PHOTO" appears and a still image will be recorded
for approx. 6 seconds, then the camcorder re-enters
the Record-Standby mode.
If you press during Recording . . .
..... "PHOTO" appears and a still image will be recorded
for approx. 6 seconds, then the normal recording
resumes.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to serial
photography. (Interval between still images: approx. 1 second)
NOTES:
● To remove the shutter sound,
● If Digital Zoom is used while in the "MULTI-4" or "MULTI-
9" mode, Snapshot recording will be performed with 10X
magnification.
● If Snapshot recording is not possible, "PHOTO" blinks when
SNAPSHOT is pressed.
● If Programme AE with special effects (
certain modes of Programme AE with special effects are
disabled during Snapshot recording. In such a case, the icon
blinks.
● If SNAPSHOT is pressed when "DIS" is set to "ON"
(
pg. 27), the Stabiliser will be disabled.
● To dub images recorded on a tape to a memory card,
pg. 60.
● When shooting in the Multi-Analyser 4 or Multi-Analyser 9
modes, the optional flash (
● During playback as well, all snapshot modes except Nega/
Posi mode are available when "
"OFF" in the Menu Screen (
● When a headphone set is connected to the PHONE
connector, the shutter sound is not heard from the speaker,
however it is recorded onto the tape.
" while pressing down the Lock
CAMERA". Press
"BEEP" on pg. 29.
pg. 34) is engaged,
pg. 83) will not light.
COPY" is set to
pg. 39).
Advertisement
Table of Contents
