Blank Search; Stop Button [5] - JVC GR-DVL157 Instructions Manual

24
EN
BLANK SEARCH Button
Power Switch
Display

BLANK SEARCH

Lock Button
44
Stop Button (5)
BASIC PLAYBACK
Blank Search
Helps you find where you should start recording in the
middle of a tape to avoid time code interruption (
1
Load a tape ( pg. 13).
2
Set the Power Switch to "
the Lock Button located on the switch.
3
Press BLANK SEARCH.
•"BLANK SEARCH" appears blinking and the
camcorder automatically starts reverse or forward
shuttle search, then stops at the spot which is about
3 seconds of tape before the beginning of the
detected blank portion.
To cancel Blank Search midway . . .
.... press 5.
NOTES:
In step 3, if the current position is at a blank portion the
camcorder searches in the reverse direction, and if the
current position is at a recorded portion the camcorder
searches in the forward direction.
Blank Search does not work if "HEAD CLEANING
REQUIRED. USE CLEANING CASSETTE" has appeared
with the tape.
If the beginning or end of the tape is reached during
Blank Search, the camcorder stops automatically.
A blank portion which is shorter than 5 seconds of tape
may not be detected.
The detected blank portion may be located between
recorded scenes. Before you start recording, make sure
there is no recorded scene after the blank portion.
(cont.)
pg. 20).
" while pressing down