Dubbing To Or From A Video Unit Equipped; With A Dv Connector - JVC GR-DVL157 Instructions Manual

To DV
Core filter
DV cable
(optional)
Core filter
To DV
IN/OUT
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Set the Power Switch to "
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the Recording Start/Stop button to engage the Record-Pause mode. "
5. Press the Recording Start/Stop button to start recording.
6. Press the Recording Start/Stop button again to engage the Record-Pause mode.
NOTES:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
During Digital Dubbing, no signals are output from the video or audio connectors.

Dubbing To Or From A Video Unit Equipped

With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
[To use this camcorder as a player]
1
Lock Button
2
Power Switch
3
4
NOTES:
" while pressing down the Lock Button located on the switch.
pg. 35).
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the illustration.
Set the camcorder's Power Switch to "
pressing down the Lock Button located on the switch,
turn on the video unit's power, and insert the
appropriate cassettes in the camcorder and the video
unit.
Press 4 to play back the source tape.
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
It is recommended to use the AC Adapter as the power
supply instead of the battery pack (
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
If "Playback Zoom" (
Effects" ( pg. 44) or "Snapshot" is attempted during
playback, only the original playback image recorded on
the tape is output from the DV connector.
When using a DV cable, be sure to use the optional JVC
VC-VDV204U DV cable.
pg. 38)
rotates.
EN
" while
pg. 9).
pg. 45), "Playback Special
" appears on the screen.
DV. IN
stops rotating.
41