Table of Contents
Advertisement
Shuttle Search
Allows high-speed search in either direction
during video playback.
1) During playback, press 5 for forward
search, or 3 for reverse search.
2) To resume normal playback, press 4/9.
● During playback, press and hold 5 or 3. The
search continues as long as you hold the button.
Once you release the button, normal playback
resumes.
● A slight mosaic effect appears on the display
during Shuttle Search. This is not a malfunction.
ATTENTION:
During Shuttle Search, parts
of the picture may not be
clearly visible, particularly on
the left side of the screen.
Blank Search
Helps you find where you should start recording
in the middle of a tape to avoid time code
interruption. (
pg. 19)
1
Load a cassette. (
2
Set the VIDEO/MEMORY Switch to "VIDEO".
3
Set the Power Switch to "PLAY" while
pressing down the Lock Button located on the
switch.
4
Press MENU. The Menu Screen appears.
5
Press MENU to select "t". The VIDEO
Menu appears.
6
Press + or – to select "BLANK SRCH", and
press MENU. The Sub Menu appears.
7
Press + or – to select "EXECUTE", and press
MENU.
● The "BLANK SEARCH" indication appears and
the camcorder automatically starts reverse or
forward search, then stops at the spot which is
about 3 seconds of tape before the beginning of
the detected blank portion.
● To cancel Blank Search, press 8.
pg. 16)
VIDEO PLAYBACK
NOTES:
● Before starting Blank Search, if the current
position is at a blank portion, the camcorder
searches in the reverse direction. If the current
position is at a recorded portion, the camcorder
searches in the forward direction.
● If the beginning or end of the tape is reached
during Blank Search, the camcorder stops
automatically.
● A blank portion which is shorter than 5 seconds of
tape may not be detected.
● The detected blank portion may be located
between recorded scenes. Before you start
recording, make sure there is no recorded scene
after the blank portion.
21
EN
Advertisement
Table of Contents
