_ _OY _ COH]'ROL
A
To program one Button of a Remote Control (Figure 37):
•
Locate Learn Button and Learn Indicator Light near
Terminal Block on Power Head (Figure 38).
•
Press and release Learn Button.
Red Learn Indicator
Light
will blink 2 times per second.
•
Press Remote Control Button once within
30 seconds.
Red Learn Indicator Light will stay lit.
•
Press Remote Control Button again. Red Learn Indicator
Light will go out, indicating that memory
is stored.
B
Program each additional
Remote using step A above.
7b E_'ase
Ail ..........
_,,
_essetes
frown
Re
e_" Mea_t
BJ]e_'_'_ery
A
Press and hold Learn Button on Power Head for 10 seconds or
until Learn Indicator
Light goes out.
Memory
is erased:
.
Program Remotes again as needed.
NOTE
e
Each Remote Control must be programmed
separately.
•
The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning.
•
When programming the Remote Controls, they
must be at least 24" from the Antenna Wire.
•
Ifthe red Learn Indicator Light blinks
approximately 4 times per second,
programming
has stopped.
If programming
has stopped, repeat the above steps.
Each Button on a 2 or 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
•
A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see "To EraseAll
Receiver Memory."
A
Push in on Battery Cover Latch at base of Remote Control
(Figure 39):
Use coin, pen, screwdriver
or any similar device.
-
Cover snaps open.
Replace old Battery with new _EI/_'RE/ID_,
A23,
12 Volt Battery.
B
Snap Battery Cover closed.
WARNING
A moving garage door may cause serious injury or death.
•
Keep people clear of opening while door is moving.
•
Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
•
Close the door and disconnect the Opener using the
Emergency Release Cord.
•
Do not use the door Opener, Remote Controls, or
Wireless Keypad.
•
Refer to the door and door Opener Owner's Manuals
before attempting any repairs.
A
Press Button on Remote Control. Garage door will move.
B
Press Button again. Garage door will stop:
•
The door automatically
stops at the end of the open or
close cycle.
C
Press Button again. Garage door will reverse.
@@@
1 Button
2 Button
3 Button
Remote
Remote
Remote
®
®
®
Figure 37 Genie Remote Controls
J
Learn Code Button
LEARN
INDICATOR
LIGHT
Figure 38 Learn Code Button and Indicator Light
Visor Clip
Model
Number
\\
Push to open
Battery Cover
Figure 39 Remote Control Battery Replacement