Cleaning; Descaling - Jura IMPRESSA X30 Instructions For Use Manual

12. Cleaning

The machine has an integrated cleaning programme. It takes about
15 minutes.
Whenever the machine needs cleaning, warning lamp
lights up. You can still draw off coffee and hot water/steam
and run the cleaning programme later.
Only use Jura cleaning tablets. They are available from your
Jura dealer.
Once the cleaning process has started, it must not be inter-
rupted.
Switch the machine on with the
Press the rinsing button for about 3 seconds. The warning
lamps , , light up.
Fill the water tank.
Empty the drip tray and the grounds container and put them back
again. The warning lamp
Place a container under the coffee spout (16) and press the
rinsing button.
The flashing of the warning lamp
programme is activated.
The cleaning process is interrupted after some minutes. The war-
ning lamp lights up on the symbol field.
Now put a Jura cleaning tablet into the filling funnel for pre-gro-
und coffee powder (12) (fig. 9) and press the
The cleaning process is continued.
If the warning lamp flashes and if the warning lamp
lights up, empty the drip tray and the grounds container and wait
switch.
goes off.
tells you that the cleansing
rinsing button.
for about 10 seconds before you put them back in again. The
warning lamp goes off. The cleaning process is completed.
After each cleaning process, the filling funnel for powder
coffee should be cleaned. For this, remove it from the
machine. Rinse it under hot running water and replace it after
drying it well.
13. De-scaling
The machine has an integrated de-scaling programme. The process
takes about 40 minutes.
If a Claris filter cartridge is used, your machine does not
need to be de-scaled.
If the machine needs de-scaling, the warning lamp
up. You can continue to draw off coffee or hot water and run
the de-scaling programme later.
Only use Jura cleaning tablets. They are available from your
Jura dealer.
Only de-scale the machine when it has been switched off for
at least 2 hours and has cooled down properly. The de-scal-
ing programme is started with the machine switched off.
Once it has started, the de-scaling process must not be inter-
rupted.
If you use descaling agents containing acid, immediately
remove any splashes and drips on sensitive work surfaces, in
particular natural rock and wooden surfaces, or take the cor-
responding precautionary measures.
In any case, wait until the descaling agent has been used up
and the tank is empty. Never top up with descaling agent.
Switch the machine off with the
for 2 hours.
lights
switch and let it cool down
13
E