Table of Contents
Advertisement
11.5 Clean machine
After 250 draw-offs or 180 rinse programme, the machine must be
cleaned. The warning
will remind you. You can still draw off
coffee and hot water/steam. However, we recommend that you
clean the machine (point 12) within the next few days. The warn-
ing lamp
then goes off after the complete cleaning process has
been carried out.
11.6 Machine furred
Your machine will become furred in the course of normal use. The
amount of furring depends on the hardness of your water. The ma-
chine registers when descalcifying becomes necessary and signals
this via warning lamp
. You can still draw off coffee and hot-
water/ steam. However we recommend that you decalcify the
machine (as described in chapter 13) within the next few days.
Warning lamp
does not go out until the complete decalcifying
process has been carried out.
11.7 Use of Claris filter cartridges
With the correct use of the Claris filter cartridges, de-scaling the
machine becomes unnecessary. For further information, please read
the instructions for use for the Claris filter cartridges. Insert the
filter (Fig. 7).
Furring display must be switched off (as described in chapter
3.7) before using Claris filter cartridges.
11.8 General cleaning instructions
Never use sharp or abrasive articles or corrosive chemicals to
clean your machine.
Wipe down the casing inside and out using a soft damp cloth.
Clean the pivoting nozzle every time it is used.
12
After warming milk, draw off a little hot-water to clean the
pivoting nozzle inside.
For thorough cleaning, you can dismantle the frothing nozzle
(Fig. 8).
The water tank should be rinsed out and filled with clean water
daily.
If you notice any furring in the water tank, this can be des-
calcified separately with a customary decalcifying product.
Remove the tank from the machine in order to do this.
If a Claris filter cartridge is used, remove it beforehand.
11.9 Regular servicing
Regular Jura services ensure your machine's reliability and longer
life. Keep the original packaging to protect the machine when it is
transported.
11.10 Emptying the system
This process is necessary to protect the machine from frost
damage while being transported.
Switch the machine off with the
Place a container under the pivoting nozzle (17).
Turn the selector switch for steam/hot water (15) to the
position.
Switch the machine on with the
Press the
(14) selector switch for about 3 sec. After a short
time, steam comes out.
Draw off steam until the flow of steam is automatically inter-
rupted.
Turn the selector switch for steam/hot water (15) back to the
position and switch the machine off.
switch.
switch.
Hide quick links:
Advertisement
Table of Contents
