Cloning - Icom IC-3FGX Instruction Manual

8

' ' Cloning

Cloning allows you to quickly and easily transfer the programmed
contents from one transceiver to another transceiver; or data from
PC to a transceiver using the optional CS-3FGX
WARE.
D D Transceiver-to-transceiver cloning
q Connect the optional OPC-474 CLONING CABLE with adapter
plugs to the [SP] jack of the master and slave transceivers.
• The master transceiver is used to send data to the slave trans-
ceiver.
w While pushing [P0] and [Y Y ], turn the transceiver's power on to
enter cloning mode (For both the master transceiver and slave
transceiver).
•
"CLONE" appears and the transceiver enters the clone standby
condition.
e Push [PTT] on the master transceiver.
•
"CLOUT" appears in the master transceiver's display.
•
"CL IN" appears automatically in the slave transceiver's display.
•
When cloning is finished, "CLONE" appears in the master trans-
ceiver's display.
NOTE: DO NOT push the [PTT] on the slave transceiver during
cloning. This will cause a cloning error.
r When cloning is finished, turn power off, then on again to return
to normal operation.
D D PC-to-transceiver cloning
Please refer to the HELP file that comes with the CS-3FGX
CLONING SOFTWARE.
CAUTION: Imprudent cloning operation causes a cloning error.
In such a case, memory contents may be lost. Cloning must
then be repeated.
21
CLONING
CLONING SOFT-