Macropower™ Total System On/Off - Universal Remote Control URC-A6 Owner's Manual

MacroPower™
for Total System On or Off
MacroPower makes several devices work
together while pressing just one button. If
you want to turn on your TV, DVD player
and audio receiver by pressing a single
button, you can. Both the Power On and the
System Off buttons can be set up this way.
Note: Most components use the same signal
to turn the power on and off. You may want
to set-up MacroPower only in the POWER
[ON] button and save the [SYSTEM OFF]
button to turn components on or off
individually.
STEP 1: To set-up MacroPower for the
POWER [ON] button, press the POWER
[ON] button and the [MUTE] button at the
same time for two seconds until any one of
the Component lights turns on. Release the
buttons before going on to step 2.
STEP 2: Press the component button you
want to turn on and then press the POWER
[ON] button; repeat for all other components
in the order you want them to turn on. The
Component light will blink once each time
you press the POWER [ON] button.
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set-up mode, and
you will have to start over with step one.
STEP 3: Once you've entered all the
Power On commands, press the CHANNEL
Up [CH ▲] button to save commands. The
Component light will blink three times to
confirm that the activation has been saved.
Repeat for System Off button if desired.
Page | 18
Replace
with
high
quality
image
Re
w
h
qu
im