Channel Control Punch Through - Universal Remote Control URC-A6 Owner's Manual

Channel Control Punch Through

This punch through lets you set up the URC-
A6 remote so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will operate in other component
modes on the remote control.
STEP 1: Press and hold the component
button you want to add channel control to,
such as [DVD] or [VCR], and the SELECT
[SEL] button at the same time for two
seconds until the Component light turns on.
Release the buttons.
STEP 2: Press the CHANNEL UP [CH▲]
button. The component LED light will blink
once.
STEP 3: Press either the [TV] or CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink three times to confirm it is saved.
Replace
with
high
quality
image
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step
one.
Page | 24