Universal Remote Control PHAZR-5 Operating Instructions Manual

Operating Instructions For
PHAZR-5
Cable Remote Control
UR5L-9000L & UR5L-9020L
Universal Remote Control, Inc.
www.universalremote.com
OCE-0087A Rev 10 (04/26/13)
1
Introduction
The PHAZR-5 UR5L-9000L & UR5L-9020L is
designed to operate the CISCO / SA,
Pioneer, Pace Micro, Samsung and
Motorola digital set tops, Plus the majority
of TV, AUD, DVD and AUX equipment on
the market as shown below.
CBL : Cable Set-top Box TV : Televisions
AUD : Audio Receivers DVD : DVD Players
AUX : Media PC, Gaming System, etc.
2

Replacing Batteries

Before you program or operate the remote control,
you must install two new AA alkaline batteries.
STEP1 Remove the battery compartment cover
on the back of your remote control.
STEP2 Check battery polarity carefully, and
install the batteries as shown in the
illustration below.
STEP3 Replace the battery compartment cover.
3

Operations

DEFAULT STATE:
Device Default: Cable Set-Top Box (STB)
Channel Default: CABLE channel and numbers
through the CABLE STB. You have the option of
controlling your CABLE channel and numbers
through the TV or AUD. Refer to section L for
programming steps.
Volume Default: Volume and Mute control are
automatically transferred to the respective
Component based on the Device selected:
CBL:Cable Set-Top Box ; TV:TV ; AUD:AUD.
DVD:TV ; AUX:AUX. You have the option of
controlling CABLE Volume and Mute through
the TV, DVD or AUD. Refer to section K for
programming steps.
4

Button Functions

5

Programming the Remote Control

IMPORTANT SETUP NOTE!
In this section when you are instructed to press a [DEVICE] button, that means to press either the CBL, TV, AUD,
DVD or AUX button, depending on what device you are programming the remote to operate.
There are four ways you can program your remote:
* Quick Set-Up Method
* The Auto-Search Method
The Quick Set-Up Method is a unique feature that enables the fastest and easiest setup by using a 1 digit
code. This is the quickest way to set up devices made by popular manufacturers.
The Pre-Programmed Code Method allows you to setup all of the buttons at once by entering 3-digit
code numbers that correspond with the components manufacture/brand. Code tables for this method
are on the backside of the operating instructions.
The Auto-Search Method scans through all of the codes in the remote control, one at a time allowing you
to identify the correct code.
The Learning Method allows you to transfer functions from other remotes to the PHAZR-5one button at a time.
IMPORTANT SETUP NOTE!
This pertains to all programming steps. When you are in setup mode the device LED will light for 30 seconds. If you do
not press a button within 30 seconds, the LED light will turn off and exit setup mode, and you will need to start over.
* The Pre-Programmed 3-Digit Code Method
* The Learning Method
A
S
S
S
S
R
(
B
C
Q
T
Q
A
Q
D
Q