Transport Control Punch Through - Universal Remote Control URC-A6 Owner's Manual

Transport Control Punch Through

This punch through enables you to program
the URC-A6 remote so that DVD Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP
and RECORD) will also operate in other
component modes on the remote control.
STEP 1: Press and hold the component
button you want to add Transport Control to,
such as [CABLE/SAT] or [TV], and the
SELECT [SEL] button at the same time for two
seconds until the Component light turns on.
STEP 2: Press the [PLAY] button. The
Component light will blink once.
STEP 3: Press either the [DVD] or [VCR]
button that you want to use as the source of
Transport Control. The component light will
blink three times to confirm it is saved.
Replace
with
high
quality
image
Note: If you do not press a
button within 30 seconds, the component
light will turn off. The remote will exit the
programming mode, and you will have to
start over with step one.
Page | 25