Specifications; An Important Word About Power Levels; Important Safety Warning - LDG IT-100 Operation Manual

SPECIFICATIONS

0.1 to 125 watts SSB and CW peak power, 30 watts on PSK and digital modes, and 100
watts on 6 meters.
Latching relays for ultra-low power operation.
2,000 memories for instantaneous frequency and band changing.
Controlled from ICOM TUNER/CALL button on radio. Powered from ICOM radio.
Works with most ICOM radios that are AH-3 or AH-4 compatible.
Partial radio list: IC-7000, IC-706 (all), IC-718 (select AH-4), IC-746.
Tuning time: 0.1 to 6 seconds full tune, 0.1 seconds memory tune.
1.8 to 54.0 MHz coverage. Built-in frequency sensor.
Tunes 4 to 800 ohm loads (16 to 150 on 6M), 16 to 3200 ohms with optional 4:1 Balun.
For dipoles, verticals, Vees, beams or any coax-fed antenna.
Includes IC-7K interface cable.
Optional external Balun allows tuning of random length, long wire or ladder line fed
antennas. See web site for details.
Dimensions: 7.25"L x 6.25"W x 1.75"H.
Weight: 1 pound.

AN IMPORTANT WORD ABOUT POWER LEVELS

The IT-100 is rated at 125 watts maximum power input at most. Many ham transmitters and
transceivers, and virtually all amplifiers, output well over 125 watts. Power levels that
significantly exceed specifications will definitely damage or destroy your IT-100. If your tuner
fails during overload, it could also damage your transmitter or transceiver. Be sure to observe the
specified power limitations.
Never install antennas or transmission lines over or near power lines. You can be
seriously injured or killed if any part of the antenna, support or transmission line touches
a power line. Always follow this antenna safety rule: the distance to the nearest power
line should be at least twice the length of the longest antenna, transmission line or
support dimension.

IMPORTANT SAFETY WARNING

PAGE 4