Uniden DSS7855 Owner's Manual page 24

Setting the Ring Time
Ring Time allows you to set the number of rings the caller hears before your answering
system plays the outgoing message. You can set the ring time to answer after four, six or
nine rings. If you enable the Toll Saver (TS), the answering system picks up after six rings if
you have new messages, and after nine rings if there are none.
1) Press the MENU soft key. Select the Answ. Setup menu,
and then the Ring Time submenu.
2) Press /volume up/down to select a Ring Time
(4 Times, 6 Times, 9 Times or Toll Saver).
3) Press the OK soft key. You will hear a confirmation tone.
Setting the Record Time
Record Time sets the duration for recording the incoming messages. You have three record
time options: "1 minute" "4 minutes" or "Announce Only". "Announce Only" answers the call
but prevents the caller from leaving a message.
1) Press the MENU soft key. Select the Answ.
Setup menu, and then the Record Time submenu.
2) Press /volume up/down to select Record Time
(1 Minute, 4 Minutes, or Announce Only).
3) Press the OK soft key. You will hear a confirmation tone.
[23]
Ring Time
9 Times
Toll Saver
BACK OK
Record time
1 Minute
4 Minutes
BACK OK