Table of Contents
Advertisement
ENGLISH
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
NOTE
• Loud test sounds may be played during Audyssey MultEQ automatic
speaker setup. This is part of normal operation. If there is background
noise in room, these test signals will increase in volume.
• Do not stand between the speakers and setup microphone or allow
obstacles in the path while the measurements are being made. This
will cause inaccurate readings.
• Make the room as quiet as possible. Background noise can disrupt
the room measurements. Close windows, silence cell phones,
televisions, radios, air conditioners, fluorescent lights, home
appliances, light dimmers, or other devices as measurements may
be affected by these sounds.
Cell phones should be placed away from all audio electronics during
the measurement process as Radio Frequency Interference (RFI)
may cause measurement disruptions (even if the cell phone is not in
use).
MASTER VOLUME
•
Operating
during the measurements will cancel
the measurements.
a Connect the Included Setup
Microphone
•
Do not remove the setup microphone until Audyssey Auto Setup is
completed.
•
When using headphones, unplug the headphones before starting
Audyssey Auto Setup procedure.
1
Check the speaker connections.
(vpage 13 "Speaker Connections")
2
Turn on the TV and subwoofer power.
Change the TV input to AVR-3310 input.
3
Turn on the AVR-3310 power.
(vpage 23 "Turning the Power On")
4
Connect the setup microphone to the SETUP MIC
jack of the AVR-3310.
Sound
receptor
"Audyssey Auto Setup"
screen is displayed when
you connect the setup
microphone.
5
Mount the setup microphone on a tripod or stand
and place it in the main listening position.
When placing the setup microphone, adjust the height of the
sound receiver part to the level of the listener's ear.
Setup
microphone
If you subwoofer provides volume and crossover settings, set these
as shown below before starting Audyssey Auto Setup.
•
Volume setting : "12 o'clock" position" or the middle of the gain
knob's range.
•
Low Pass Filter setting : Low Pass Filter Setting to "Off", or
"Maximum/Highest Frequency".
•
Phase setting : 0°
•
Standby mode setting : "Off"
NOTE
•
Do not hold the microphone in your hand during measurements.
•
Avoid placing the microphone close to a seat back or wall as sound
reflections may give inaccurate results.
Hide quick links:
Advertisement
Table of Contents
