BMW 525i Owner's Manual page 54

Sedan
If you use a child-restraint system with a tether
strap, three additional tether anchorage points
have been provided, refer to the arrows in the
illustration. Depending on the location selected
for sitting in the rear passenger area, attach the
tether strap to the corresponding anchorage
point to secure the child-restraint system, as
shown in the illustration below. To use the
anchor fittings, fold them upwards.
After removing the child-restraint system,
fold in the anchor fitting, as otherwise
there is a danger of injury.<
Sports Wagon
If you use a child-restraint system with a tether
strap, three additional tether anchorage points
have been provided, refer to the arrows in the
illustration. The anchor fittings are located
Online Edition for Part-No. 01 41 0 159 251 © 03/05 BMW AG
beneath the load area floor. To gain access to
the anchor fitting, remove the plastic cover with
the help of a screwdriver. Depending on the
location selected for sitting in the rear passen-
ger area, attach the tether strap to the corre-
sponding anchorage point to secure the child-
restraint system, as shown in the illustration
below.
Placement of tether strap
Outer sitting positions:
Lift the head restraint and pass the tether strap
between the head restraint and the seat back. It
is recommended to readjust the head restraint
into the lowest possible position.
Center sitting position:
Pull the center armrest forward somewhat to
guide the tether strap through the opening.
Then reengage the center armrest.
Adjust the tether strap according to the
child-restraint manufacturer's instruc-
tions.<
53