IBM 6223 User Manual page 93

Table 5. POST error messages (continued)
POST message Description
1806 A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory below 1
MB.
Action: Remove the PCI adapter that has the PCI bridge. If you can start the computer
without the adapter, reinstall and retest the adapter. If the adapter fails, replace it.
If you cannot isolate and correct the problem, call for service.
1807 xxxxyyyy Planar PCI device does not respond or disabled by user. (Where xxxx is the PCI
vendor ID and yyyy is the PCI device ID.)
Action: Start the Configuration/Setup Utility program, select Devices and I\O Ports, and make
sure that the device is enabled. If the problem remains, call for service.
1808 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the computer without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails, replace
it.
If the problem remains, call for service.
1962 No valid startup devices were found. The computer cannot find the startup drive or operating
system.
Action: Make sure that the drive you want to start from is in the startup sequence.
1. Select Start Options from the Configuration/Setup Utility program main menu. If you are
2. Check the list of startup devices in the Startup device data fields. Is the drive you want to
3. Is an operating system installed?
4. During computer startup, watch for messages indicating a hardware problem.
If the same error message appears, call for service.
2462 A video memory configuration error occurred.
Action: Call for service.
5962 An IDE CD-ROM configuration error occurred.
Action: Check the signal and power cable connections to the CD-ROM drive.
If the problem remains, call for service.
unable to set the startup sequence, call for service.
start from in the startup sequence?
Yes Exit from this screen; then, select Exit Setup to exit the Configuration/Setup
menu. Go to step 3..
No Follow the instructions on the screen to add the drive; then, save the changes and
exit the Configuration/Setup menu. Restart the computer.
Yes Turn off the computer. Go to step 4.
No Install the operating system in the computer; then, follow your operating-system
instructions to shut down and restart the computer.
Chapter 5. Solving problems
79