Icom IC-M801GMDSS Instruction Manual page 67

I Connector information (continued)
PRINTER Pin
1
2–9
10
13..........................1
11
25.......................14
12–14
Front panel view
15
16, 17
18–25
REMOTE Pin Pin name
1 DATA-OUT (–) Ground (not transceiver's ground) for
2 DATA-OUT (+) IEC61162-1: 2000 data output.
3 DATA-IN (+) IEC61162-1: 2000 data input.
5 1
4 DATA-IN (–) Ground (not transceiver's ground) for
5
9 6
Front panel view
6
7
8
9
NOTE: The IC-M801GMDSS supports IEC61162-1: 2000 data with FSI, SFI DSC and DSE sentences only.
RCA Pin name
GPS IN (+)
GPS IN (+) GPS data input in IEC61162-1: 2000 format. Input level : Less than 2 mA (when 2 V ap-
RCA
GPS IN (–) Ground (not transceiver's ground) for GPS-
GPS IN (–)
NOTE: The IC-M801GMDSS supports IEC61162-1: 2000 GPS data with GGA, GNS, GLL and RMC sentences, and UTC of
position (excludes second unit or less), latitude and longitude information only.
Pin name
STROBE Outputs a strobe pulse after data output.
DATA1–8 Outputs 8-bit parallel data.
Input port for the connected printer.
ACKNLG
"Low" pulse signal is applied from the printer during the printer accepts data input.
Input port for the connected printer.
BUSY "High" level signal is applied from the printer during the printer cannot accept data
input, such as when off line.
NC No connection.
Input port for the connected printer.
ERROR
The printer output becomes "Low" when an printer error, such as no paper, occurs.
NC No connection.
GND Ground terminals.
Description
DATA-OUT (+) terminal.
DATA-IN (+) terminal.
GND Connected to the ground.
NC No connection.
NC No connection.
NC No connection.
NC No connection.
Description
IN (+) terminal.
CONNECTION AND INSTALLATION
Description
Specification
Output level : 40 mA max. (as a talker)
Input level : Less than 2 mA (when 2 V
applied; as a listener)
Specification
plied; as a listener)
13
13
63