What To Do If - Electrolux EHD60140P User Manual

28 electrolux what to do if ...

What to do if ...

Problem
The appliance cannot be
switched on or is not operating
The residual heat indicator is
not displaying anything
The automatic warm up func-
tion is not switching itself on
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds when
appliance is switched off
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5 sec-
onds another acoustic signal
sounds
Display is switching between
two heat settings
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The lock is switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
The cooking zone was only on
for a short time and is therefore
not hot
There is still residual heat on
the cooking zone
The highest heat setting is set The highest heat setting has
One or more sensor fields
have been covered for longer
than 10 seconds
The control panel is wholly or
partly covered by objects.
The On/Off sensor field has
been covered up, e.g. by a
cloth
Power management is reduc-
ing the power of this cooking
zone
Remedy
Switch the appliance on again.
Switch off the lock (See the
section "Locking/unlocking
the control panel")
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Let the cooking zone cool
down
the same power as the auto-
matic warm up function
Uncover sensor field
Remove objects.
Do not place any objects on
the control panel
See the section "Switching the
power function on and off"