Electrolux EHD60140P User Manual page 29

Problem
flashes
is lit
and number are displayed Electronics fault
and minus are displayed
If you are unable to remedy the
problem by following the above
suggestions, please contact your
dealer or the Customer Care De-
partment.
Warning! Repairs to the appliance
are only to be carried out by quali-
fied service engineers. Considera-
ble danger to the user may result
from improper repairs.
If the appliance has been wrongly op-
erated, the visit from the customer
service technician or dealer may not
take place free of charge, even during
the warranty period.
Possible cause
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom of
the cookware is too small for
the cooking zone
Overheating protection for the
cooking zone has been trig-
gered
Automatic switch off has been
triggered
Light rays that are too strong
on the control panel, for exam-
ple bright sunlight
what to do if ... electrolux 29
Remedy
Use suitable cookware
Place cookware on the cook-
ing zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the
customer service department
Briefly shade the control panel,
for example with the hand
Acoustic signal sounds, appli-
ance switches itself off Switch
appliance on (again)