Table of Contents
Advertisement
18 electrolux
CARE AND CLEANING
Warning! Refer to "Safety information"
chapter.
• Clean the front of the appliance with a
soft cloth with warm water and cleaning
agent.
• To clean metal surfaces use a usual clean-
ing agent
• Clean the oven interior after each use.
Thus you can remove dirt more easily
and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories (with a soft
cloth with warm water and cleaning
agent) after each use and let them dry.
• If you have nonstick accessories, do not
clean them using an aggressive agents,
sharp edged objects or dishwasher. It
can destroy nonstick coating!
Pyrolytic cleaning
1. Remove all parts from the oven.
If you do not remove the shelf support
rails, the clock display shows 'C1' and
pyrolytic cleaning procedure cannot
start.
2. Remove the worst of the residue man-
ually.
3. Set oven function Pyroluxe menu
– " PYR 1 " appears in the display,
– Duration
ly 5 seconds.
While Duration
rolyse time button to set the necessary
length for the procedure.
– For more dirt, press the button once
to set " PYR 1 " (3:15 - Pyroluxe
menu intensive).
– For less dirt press the button twice to
set " PYR 2 " (2:15 - Pyroluxe menu
light).
If Duration
the Selection button again and then set
length for the pyrolytic procedure.
You can also change switch off time for
pyrolytic cleaning using the clock func-
tion End
(within 2 minutes of the py-
rolytic cleaning starts).
4. Pyrolytic cleaning starts.
flashes for approximate-
flashes, press the Py-
no longer flashes, push
During pyrolytic cleaning the light does
not operate.
When the oven reaches pre-set temper-
ature, the door locks.
The bars of the heat indicator come up,
until the door unlocks again.
Shelf Support Rails
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away from
the side wall and remove it.
2
1
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front!
Oven lamp
Warning! There is a danger of
electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Advertisement
Table of Contents
