Table of Contents
Advertisement
Master/Slave
Mode
Infrared Control
Page 14 of 18
The Master/Slave mode allows a single SlimPAR™ Tri IRC series unit (the "master") to
control the actions of one or more SlimPAR™ Tri IRC series units (the "slaves") without
the need of a DMX controller. The master unit will be set to operate in either Automatic
or Static Color mode, while the slave units will be set to operate in Slave Mode. Once set
and connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1.
Press <MENU> repeatedly until 3-CH shows on the display.
2.
Press <ENTER> to accept.
3.
Set the DMX address to 001.
4.
Connect the DMX input of the first slave unit to the DMX output of the master unit.
5.
Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6.
Finish setting and connecting all the slave units.
Master unit:
1.
Set the master unit to operate in either Automatic or Static Color mode.
2.
Make the master unit the first unit in the DMX daisy chain.
•
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master
unit.
•
Do not connect more than 31 slave units to the master unit.
•
When using the Master/Slave mode with the IRC, set the slave units to
7-channel mode to ensure the best performance.
The SlimPAR™ Tri IRC series is fully compatible with the IRC Infrared Remote Control
from CHAUVET®. To enable usage with the IRC, follow the instructions below:
1.
Press <MENU> repeatedly until SEr shows on the display.
2.
Press <ENTER>.
Press <UP> or <DOWN> to turn the feature on or off.
3.
4.
Press <ENTER>.
For IRC operation instructions, refer to the following page.
SlimPAR™ Tri IRC series User Manual (Rev. 5)
Advertisement
Table of Contents
