Mounting
Orientation
Rigging
Mounting Diagram
(SlimPAR™ Tri 12 IRC
shown)
SlimPAR™ Tri IRC series User Manual (Rev. 5)
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The SlimPAR™ Tri IRC series may be mounted in any position; however, make sure
adequate ventilation is provided around each product.
•
Before deciding on a location for the product, always make sure there is easy
access to the product for maintenance and programming purposes.
•
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
•
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity.
•
When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
•
The double-bracketed yoke/mounting brackets/rubber feet/metallic feet also serve
as floor supports/allow for surface mounting. When mounting the product on the
floor, make sure that the product and cables are away from people and vehicles.
Gel Frame Holder
Bracket
Adjustment Knob
Mounting Bracket
Gel Frame
Technical
Specifications).
Page 11 of 18