Master/Slave Mode; Master/Slave For Sound-Active, Auto Modes; Service Mode - Chauvet Intimidator Scan LED 300 User Manual

Master/Slave
Mode
Master/Slave for
Sound-Active,
Auto Modes

Service Mode

Intimidator™ Scan LED 300 User Manual Rev. 6
The Master/Slave mode allows a single Intimidator™ Scan LED 300 unit (the "master")
to control the actions of one or more Intimidator™ Scan LED 300 units (the "slaves")
without the need of a DMX controller. The master unit will be set to operate in either
Auto program or Sound-Active mode, while the slave units will be set to operate in Slave
mode. Once set and connected, the slave units will operate in unison with the master
unit.
Configure the units as indicated below.
Slave units:
1. Press <MODE/ESC> repeatedly until SLAu shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d001.
4. Connect the DMX input of the first slave unit to the DMX output of the master unit.
5. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in either Auto program or Sound-Active mode.
2. Make the master unit the first unit in the DMX daisy chain.
Configure all the slave units before connecting the master unit to the DMX daisy
chain.
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master
unit.
Do not connect more than 31 slave units to the master unit.
Master/Slave may also be used to synchronize a maximum of 31 slave units to a single
master set to any of the standalone modes:
Set the master product in any of the Standalone modes: Sound-Active mode or Auto
programs.
To set the slave products:
1. Press <MODE/ESC> until NASL appears on the LED screen.
2. Using <UP> and <DOWN> select <SLAu>.
3. Press < ENTER >. <SoN> will appear on the screen.
The Intimidator™ Scan 300 has an imbedded menu that requires a passcode for use.
The purpose of this menu is to electronically adjust the home positions of various
features. To access this menu:
1. Press < MODE/ESC > and hold for at least 10 seconds.
2. Using <UP> and <DOWN>, enter the following pass code: "2323". Press <UP> to
change the blinking digit in ascending order, and press <DOWN> to move on to the
next digit.
3. Press <ENTER>.
Menu Option Selection
P128 000–255
t128 000–255
G128 000–255
r128 000–255
C128 000–255
F128 000–255
Note: This mode will automatically terminate after 10 seconds of being idle.
Instruction
Adjustment for pan
Adjustment for tilt
Adjustment for the gobo wheel
Adjustment for the gobo wheel rotation
Adjustment for the color wheel
Adjustment for the focus
Page 13 of 17