Table of Contents
Advertisement
Serial number (S.N.)
14. INSTALLATION
WARNING!
Refer to the Safety chapters.
The appliance is designed to be connec-
ted to 230 - 240V ~ (50Hz) electricity sup-
ply.
The appliance has an easily accessible
terminal block which is marked as follows:
Letter L - Live terminal
Letter N - Neutral terminal
Connection via
Cooker Control
Circuit
It is necessary that you install a double
pole switch between the oven and the
electricity supply (mains), with a minimum
gap of 3 mm between the switch contacts
and of a type suitable for the required
load in compliance with the current regu-
lations.
The switch must not break the yellow and
green earth cable at any point.
After installation and connecting,
the cable must be placed so that
it cannot at any point reach a tem-
perature of more than 50°C above
the ambient temperature.
Before the oven is connected,
check that the main fuse and the
domestic installation can support
the load; and that the power sup-
ply is properly earthed.
Min. size Cable/
flex
2,5 mm²
min.
3 mm
.........................................
- Earth terminal
CAUTION!
This appliance must be earthed!
The cable used to connect the oven to
the electrical supply must comply to the
specifications given below.
For UK use only
Cable/flex type
PVC / PVC twin
and earth
The manufacturer declines any re-
sponsibility should these safety
measures not be carried out.
The built-in unit must meet the
stability requirements of DIN
68930.
ENGLISH
39
Fuse
min: 15 A
max: 20 A
Advertisement
Table of Contents
