Table of Contents
Advertisement
Installation
Work on the cooker must be carried out by a qual-
ified electrician. The cooker is heavy. Certain
edges and corners which will not normally be
exposed may be sharp.
the cooker.
Before installing the cooker, you should check that its
dimensions correspond to the rest of your kitchen
units. Measure the height of the worktop from floor to
top surface of the worktop, and the plinth depth from
the wall to the front edge of the plinth (see illustra-
tion). The cooker may also be installed adjoining one
wall or one tall unit on one side, and a worktop on the
other side.
When delivered, the cooker plinth is adjusted to suit a
worktop height of 90 cm and a plinth depth of 53 cm.
You can alter the height and depth of the plinth to make
the cooker suitable for a worktop height of 85, 88 or 90
cm and a plinth depth of 55 cm (see below).
Check the cooker cable is not trapped when moving
the cooker.
To adjust plinth height and depth
53 cm is the minimum plinth depth for this
cooker. Setting a smaller plinth depth can cause
the cooker to tip if a heavy weight is placed on
the door.
If you wish to alter both dimensions, you should adjust
both at the same time. But make sure you read through
the full instructions before starting work.
1 Carefully lay the cooker on its back (
). Use some of the packaging material to
STRATION
cushion the cooker on the floor surface.
2 Unscrew the four screws (A), see the illustra-
tion. If you are altering the cooker height only,
pull the inner plinth out a certain distance. Grasp
the brackets which hold the wheels and feet.
! Be careful, there are sharp edges under
NOTE
the cooker. Go to point 5 and continue from
there. If altering the plinth depth, you should
pull the plinth completely out.
3 Unscrew the four screws (B), see the illustration.
Then remove the outer plinth.
4 Position the outer plinth at the 55 cm setting
(
SEE ILLUSTRATION
(don't forget the washers) and push the inner
plinth inwards a little.
when moving
USE GLOVES
SEE ILLU
B). Screw in the (B) screws
-
90
88
53
55
85
Installation
19
Hide quick links:
Advertisement
Table of Contents
