AMT Datasouth Accel-7450 User Manual page 16

4.
Set fanfold paper onto the tractors. Release the lock lever to adjust
the tractors right /left to fit the pin feed paper width.
5.
Use the zero 0 mark on the ruler label attached to the back of the
printer as a reference to line up the starting print position by sliding
the tractors left or right.
Adjust the tractors so the paper is snug between them without
tearing or elongating the pin fed holes.
6.
To select the rear tractors as the paper feed source, slide the paper
path lever on the printer front panel to the rear tractor symbol:
Note: The lever position can be at "AUTO" only when using the
printer driver to select paper sources.
7.
If the paper length is not 11 inches (factory default), specify the
appropriate length in the printer's control panel menu item #6
"TRACTOR PAGE LGTH".
CAUTION
- 16 -
ACCEL- 7450
Do not put your finger
under the tractor cover.