Dubbing - TDK DA-5700 User Manual

5700 USER MANUAL ENG(b) 4/22/02

Dubbing

This section describes how to make a copy of a disc in TRAY I to an
audio CD-R or CD-RW in TRAY II.
1. Press POWER to turn the unit ON.
2. Place the disc to be dubbed in TRAY I, and put a recordable
CD-R/RW disc in TRAY II.
3. Close both trays. When the blank disc is inserted and TRAY II
is closed, the display will show a BLANK message.
4. Press the DUBBING MODE button to select the dubbing speed.
Every time the DUBBING MODE button is pressed, the dubbing
speed is changed.
DUBB 4X: records four times as fast as the normal playback speed
DUBB 2X: records twice as fast as the normal playback speed
DUBB 1X: records at normal playback speed
5. Press TRAY II's PLAY (ENTER) [
If the CD-R/RW disc in TRAY II doesn't have enough space to dub the entire
disc in TRAY I, NOSPACE:D2 and DUBB 1/2/4X will alternately appear on
the display. Even if this happens, you can still dub part of the disc.
To dub as much of the disc as possible, press the PLAY [ ] button
•
when DUBB 1/2/4X is displayed.
When the disc nears the end of its available recording space,
•
the unit will do a fade-out over a few seconds.
When the fade-out has finished, the unit will finalize the disc
•
and automatically stop.
Pressing STOP [ I ] will stop the dubbing process.
•
When dubbing is stopped by pressing STOP [
•
the disc will not be finalized.
During dubbing, only the STOP [
•
will work.
Track numbers are incremented automatically. During dubbing,
•
you cannot add track numbers manually.
Note that the unit is more tolerant of disc errors at slower
•
dubbing speeds. If you're using low quality CD-R or CD-RW discs
(or if your source disc is scuffed), and you're experiencing
problems, record at 1X.
If you intend to monitor the sound during high speed dubbing,
•
turn the volume of your amplifier down low to prevent possible
damage to your system.
14
7:41 PM Page 14
] button to start recording.
I ],
I ] buttons of TRAY I and II
ABOUT 2X/4X SPEED DUBBING
When playback of the disc in TRAY 1 ends, the unit stops
recording, finalizes the disc, stops and the following messages
are then displayed:
PMA WRITE
COMPLETE
FINALIZE
COMPLETE
It takes about 1 minute to finalize the disc.
During high speed dubbing, SYNC ALL is selected automatically.
You cannot select SYNC 1.
VERY IMPORTANT NOTE
If you attempt to dub a disc that contains SCMS copy protection, the
message, SCMS, will appear on the DA-5700. After 3 seconds, PRESS
ENTER will appear on the display. If you press PLAY (ENTER) [
ANALOG MODE will appear on the display, then the unit will record
the entire disc at 1X speed in analog mode. When recording is
finished, the unit will automatically finalize the disc.
ABOUT 1X SPEED DUBBING
When the playback of the disc in TRAY 1 ends, the unit stops
recording and the following messages will be displayed:
PMA WRITE
COMPLETE
During 1X speed dubbing, SYNC ALL is selected automatically. If you
want to select SYNC 1, see the ADVANCED RECORDING section of
the manual.
Discs recorded at 1X speed will not be automatically finalized.
],