Load Setup Defaults - Abit BM6 User Manual

BIOS Setup
If you specify the IRQ in this item, then you cannot specify the same IRQ to the ISA
bus, otherwise, it will cause a hardware conflict.
You must be familiar with the PCI interrupt distribution mechanism to adjust this setting.
This feature is for the operating system which will record and fix the PCI configuration
status, if you want to change it.
For the relations between the hardware layout of PIRQ (the signals from the PIIX4 chipset),
INT# (means PCI slot IRQ signals) and devices, please refer to the table below:
Signals PCI slot 1
AGP slot
PIRQ_1 INT A
PIRQ_2 INT B
PIRQ_3 INT C
PIRQ_4 INT D
l USB used PIRQ_4.
l Each PCI slot has four INT#s (INT A~INT D), and the AGP slot has two INT# (INTA and
INT B).

3-7. Load Setup Defaults

Setup defaults are the settings that allow your system to operate at its highest performance.
When you choose this option, the following message is displayed:
If you want to use BIOS Setup default values, press "Y", then <Enter> to complete the
loading of the settings for best performance.
You should first load the best settings, than enter the CPU Soft Menu to set up CPU
parameters, otherwise the BIOS will replace set parameters by default parameters.
User's Manual
Note
PCI slot 2
INT D
INT A
INT B
INT C
"Load Setup Defaults (Y/N)? N"
PCI slot 3 PCI slot 4
PCI slot 5
INT C INT B
INT D INT C
INT A INT D
INT B INT A
3-29