Power Management - Abit BM6 User Manual

3-22
System States and Power States
Under ACPI, the operating system directs all system and device power state transitions. The
operating system puts devices in and out of low-power states based on user preferences and
knowledge of how devices are being used by applications. Devices that are not being used
can be turned off. The operating system uses information from applications and user settings
to put the system as a whole into a low-power state.
Table 5-1: Wake Up Device and Events
The table below describes which devices or specific events can wake the computer from
specific states.
These device/events can wake up the
computer ......
Power switch
RTC alarm
LAN
Modem
IR command
USB
PS/2 keyboard
PS/2 mouse
Sleep button
Table 5-2: Effect of Pressing the Power Switch
If the system is in this
state ......
Off
On
On
Sleep

Power Management:

Four options:
ä User Define
User Define defines the delay for accessing the power modes.
ä Min Saving
When the three saving modes are enabled, the system is set up for minimum power
savings.
...... from this state
Sleeping mode or power off mode
Sleeping mode or power off mode
Sleeping mode or power off mode
Sleeping mode or power off mode
Sleeping mode
Sleeping mode
Sleeping mode
Sleeping mode
Sleeping mode
...... a n d the power switch
is pressed for
Less than four seconds
More than four seconds
Less than four seconds
Less than four seconds
Chapter3
...... the system enters this
state
Power on
Soft off/Suspend
Fail safe power off
Wake up
BM6