What To Do If - Electrolux EHD 6676 P Installation And Operating Instructions Manual

What to do if ...

Problem
The appliance cannot be switched
on or is not operating
The residual heat indicator is not
displaying anything
The automatic warm up function is
not switching itself on
Repeated acoustic signal (6x), ap-
pliance switches off
Acoustic signal sounds when appli-
ance is switched off
Acoustic signal sounds and appli-
ance switches itself on and then off
again; after 5 seconds another
acoustic signal sounds
Display is switching between two
heat settings
flashes
is lit
18
Possible cause
More than 10 seconds have passed
since the appliance was switched
on
The lock is switched on
The child safety device is switched
on
Several sensor fields were touched
at the same time
Safety cut-out has been triggered
The cooking zone was only on for a
short time and is therefore not hot
There is still residual heat on the
cooking zone
The highest heat setting is set
One or more sensor fields have
been covered for longer than 10
seconds
The control panel is wholly or partly
covered by objects.
The On/Off sensor field has been
covered up, e.g. by a cloth
Power management is reducing the
power of this cooking zone
Unsuitable cookware
No cookware on the cooking zone
The diameter of the bottom of the
cookware is too small for the cook-
ing zone
Overheating protection for the
cooking zone has been triggered
Safety cut-out has been triggered
Remedy
Switch the appliance on again.
Switch off the lock (See the section
"Locking/unlocking the control
panel")
Deactivate child safety device (See
the section "Child safety device")
Only touch one sensor field
Remove any objects (pan, cloths,
etc.) that are lying on the control
panel. Switch the appliance on
again
If the cooking zone is supposed to
be hot, call the Customer Service
Department.
Let the cooking zone cool down
The highest heat setting has the
same power as the automatic warm
up function
Uncover sensor field
Remove objects.
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on again
Switch off the cooking zone.
Switch the cooking zone on again