Safety Cut-Out - Electrolux EHD 6676 P Installation And Operating Instructions Manual

Safety cut-out

Cooking surface
• If after switching on the cooking surface, a heat
setting is not set for a cooking zone within approx.
10 seconds, the cooking surface automatically
switches itself off.
• If one or more sensor fields are covered for longer
than approx. 10 seconds, e.g. by a pan placed
upon it, a signal sounds and the cooking surface
switches off automatically.
• If all cooking zones are switched off, the cooking
surface automatically switches itself off after ap-
prox. 10 seconds.
Control panel
• When the appliance is switched off, if one or more
of the sensor fields on the control panel are cov-
ered for more that 10 seconds, an acoustic signal
sounds. The acoustic signal switches itself off au-
tomatically when the sensor fields are no longer
covered.
Induction cooking zones
• In the event of overheating (e.g. when a pan boils
dry) the cooking zone automatically switches itself
off. is displayed. Before being used again, the
cooking zone must be set to 0 and allowed to cool
down.
• If cookware that is not suitable is used,
in the display and after 2 minutes the display for
the cooking zone switches itself off.
all cooking zones
• If one of the cooking zones is not switched off after
a certain time, or if the heat setting is not modified,
the relevant cooking zone switches off automati-
cally. is displayed. Before being used again, the
cooking zone must be set to 0.
Heat setting
V, 1 - 2
3 - 4
5
6 - 9
flashes
Switches off after
6 hours
5 hours
4 hours
1.5 hours
13