HP ENVY 15 Maintenance And Service Manual page 99

2. Remove the TouchPad bracket (2).
3. Release the two pieces of grounding tape (1) that connect the TouchPad to the top cover.
4. Remove the four Phillips PM2.5×2.5 broad head screws (2) that secure the TouchPad to the
top cover.
NOTE: The second and third screws include two rubber washers (3). These washers are crucial
to the performance of the TouchPad.
5. Lift the rear edge of the TouchPad (4) until it rests at an angle.
Component replacement procedures
91