Power Connector Cable - HP ENVY 15 Maintenance And Service Manual

Power connector cable

Description
For use on all computer models equipped with a graphics subsystem with UMA memory
For use only on computer models equipped with an Intel processor and a graphics subsystem with
discrete memory
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Solid-state drive (see
b. Hard drive (see
c. Base enclosure (see
Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Release the power connector cable from the clips (2) built into the keyboard shield.
3. Release the power connector (3) from the clips and mold built into the top cover.
4. Remove the power connector cable.
82 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 43), and then remove the following components:
Solid-state drive on page
Hard drive on page 47)
Base enclosure on page
44)
55)
Spare part number
720537-001
720538-001