Hard Drive - HP ENVY 15 Maintenance And Service Manual

Reverse this procedure to install the WLAN module.

Hard drive

Description
1-TB, 5400-rpm, 9.5-mm
750-GB, 5400-rpm, 9.5-mm
500-GB, 5400-rpm, 9.5- and 7.0-mm
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5.
Remove the service cover (see
Remove the hard drive:
1. Release the zero insertion force (ZIF) connector (1) to which the hard drive connector cable is
attached, and then disconnect the hard drive connector cable (2) from the system board.
2. Release the hard drive connector cable (3) from the opening in the base enclosure.
Battery on page 43).
Solid-state drive on page
Spare part number
676521-001
634250-001
683802-001
44).
Component replacement procedures
47